LOCATION：HOME > NEWS >

Cause of abnormal noise bearing

Time：2017-09-21 15:20:19Hits：625

Cause of abnormal noise bearing 1. Grease impurities; 2. Insufficient lubrication (oil level is too low, save improper seal leakage by oil or grease); 3. Bearing clearance is too small or too large (plant issues); 4. Bearing mixed impurities such a

Cause of abnormal noise bearing

1. Grease impurities;

2. Insufficient lubrication (oil level is too low, save improper seal leakage by oil or grease);
3. Bearing clearance is too small or too large (plant issues);
4. Bearing mixed impurities such as sand or soot, played abrasive effect;
5. Bearing mixed with water, acids and other dirt or paint, play a corrosive effect;
6. Bearing housing bore clamp is flat (bad seat hole roundness or housing bore distortion is not straight);
7. Bottom surface of the horn bearing uneven (resulting in deformation of the housing bore even bearing cracks);
8. Bearing hole with debris (residual chips, dust, etc.);
9. Eccentric ring (across adjacent parts and friction);
10. Subject to additional load bearing (bearing by the axial limp tight, or a shaft has two fixed end bearings);

11. Bearings and shaft too loose (smaller diameter shaft or adapter sleeve not tighten); 12. The bearing clearance is too small, too tight (tight sets tightened too overdone) rotates;

-------------------------------------------------------------------

Contact Us:

Mr. Shawn
Mobile: +86-18766165306
Email: aobobearing@aobobearings.com
Skype: live:aobobearing
Wechat: aobobearing
Tel: +86-0531-88785536
Fax: +86-0531-88785636
Website: http://www.aobobearings.com